Amp Section (WIP)

Within each Machine, the sound source goes through a Filter section and is then routed to the same Amp section.
Each Amp section is then routed to the Mixer.

The Amp section is always on Tab 4 in every Machine.
This amp tab offers settings related to amplitude and distortion:

Drive Type	Drive	DCA1	DCA2
Select one of the 29 distortion algorithms. Read the chart below for details regarding each one.	Controls the amount of distortion	The first Digitally Controlled Amplifier. DCA1 and DCA2 are routed in series, with 1 usually modulated by velocity and 2 modulated by an envelope. But you can set modulations as you wish.	The second Digitally Controlled Amplifier. DCA1 and DCA2 are routed in series, with 1 usually modulated by velocity and 2 modulated by an envelope. But you can set modulations as you wish.

Distortion algorithms reference:

reference

Off
Soft
Medium
Hard
Diode
The Drive section is bypassed	???	???	???	???
Demon
Soft Fold
Diode Fold
Dual Frequency	Tube
???Tube	???	???	???	???
Sigmoid
Tape Dynamics
Tape Hysteresis
Tape Curve
Tape Noise
???	???	???	???	???
Hard Clipping
Fuzz
Chebyshev
Half Rectifier
Full Rectifier
???	???	???	???	???
Transistor
Dynamic
Asymmetric
Feedback
Zero Crossing
???	???	???	???	???
Bit Reaper
Sample Reaper
Sample Reduction
Bitwise
Ring Modulation
???	???	???	???	???

Page 3 allows for filter routing options:

Routing	Balance between filter 1 and 2	-	-
Select a routing configuration for the filters. Single enables only filter 1. Serial routes the output of Filter 1 to Filter 2. Para will route both filters in parallel Split will split the sound sources into the two filters, depending on the Machine select.	Controls the volume of both filters at the output. Fully clockwise only filter 2 will be heard, and fully counter-clockwise it will be only filter 1.	-	-