Amp Section (WIP)
Within each Machine, the sound source goes through a Filter section and is then routed to the same Amp section.
Each Amp section is then routed to the Mixer.
The Amp section is always on Tab 4 in every Machine.
This amp tab offers settings related to amplitude and distortion:
| Drive Type | Drive | DCA1 | DCA2 |
|
Select one of the 29 distortion algorithms. Read the chart below for details regarding each one. |
Controls the amount of distortion | The first Digitally Controlled Amplifier. DCA1 and DCA2 are routed in series, with 1 usually modulated by velocity and 2 modulated by an envelope. But you can set modulations as you wish. | The second Digitally Controlled Amplifier. DCA1 and DCA2 are routed in series, with 1 usually modulated by velocity and 2 modulated by an envelope. But you can set modulations as you wish. |
Distortion algorithms reference
| Off | |
| Soft | |
| Medium | |
| Hard | |
| Diode | |
| Demon | |
| Soft Fold | |
| Diode Fold | |
| Dual Frequency | |
| Tube | |
| Sigmoid | |
| Tape Dynamics | |
| Tape Hysteresis | |
| Tape Curve | |
| Tape Noise | |
| Hard Clipping | |
| Fuzz | |
| Chebyshev | |
| Half Rectifier | |
| Full Rectifier | |
| Transistor | |
| Dynamic | |
| Asymmetric | |
| Feedback | |
| Zero Crossing | |
| Bit Reaper | |
| Sample Reaper | |
| Sample Reduction | |
| Bitwise | |
| Ring Modulation |