Amp Section
Within each Machine, the sound source goes through a Filter section and is then routed to the same Amp section.
Each Amp section is then routed to the Mixer.
The Amp section is always on Tab 4 in every Machine.
This amp tab offers settings related to amplitude and distortion:
| Drive Type | Drive | DCA1 | DCA2 |
|
Select one of the 29 distortion algorithms. Read the chart below for details regarding each one. |
Controls the amount of distortion | The first Digitally Controlled Amplifier. DCA1 and DCA2 are routed in series, with 1 usually modulated by velocity and 2 modulated by an envelope. But you can set modulations as you wish. | The second Digitally Controlled Amplifier. DCA1 and DCA2 are routed in series, with 1 usually modulated by velocity and 2 modulated by an envelope. But you can set modulations as you wish. |
Distortion algorithms reference:
| Off | Soft | Medium | Hard | Diode |
| The Drive section is bypassed | ??? | ??? | ??? | ??? |
| Demon | Soft Fold | Diode Fold | Dual Frequency | Tube |
| ??? | ??? | ??? | ??? | ??? |
| Sigmoid | Tape Dynamics | Tape Hysteresis | Tape Curve | Tape Noise |
| ??? | ??? | ??? | ??? | ??? |
| Hard Clipping | Fuzz | Chebyshev | Half Rectifier | Full Rectifier |
| ??? | ??? | ??? | ??? | ??? |
| Transistor | Dynamic | Asymmetric | Feedback | Zero Crossing |
| ??? | ??? | ??? | ??? | ??? |
| Bit Reaper | Sample Reaper | Sample Reduction | Bitwise | Ring Modulation |
| ??? | ??? | ??? | ??? | ??? |
Page 3 allows for filter routing options:
| Routing | Balance between filter 1 and 2 | - | - |
| Select a routing configuration for the filters. Single enables only filter 1. Serial routes the output of Filter 1 to Filter 2. Para will route both filters in parallel Split will split the sound sources into the two filters, depending on the Machine select. |
Controls the volume of both filters at the output. Fully clockwise only filter 2 will be heard, and fully counter-clockwise it will be only filter 1. | - | - |