Amp Section
General information
DriveWithin Typeseach Machine, the sound source goes through a Filter section and whyis therethen arerouted to the same Amp section.
Each Amp section is then routed to the Mixer.
The filter section has 3 pages containing different controls. When a Tab header displays small bar icons, click its corresponding button underneath to jump between its pages.
Page 1:
| Filter 1 Frequency | Filter 1 Resonance | (Filter Morph) -or- (Filter Gain) |
Filter 1 Type |
|
Controls the filter's cutoff frequency |
Controls the filter's resonance amount |
Morph between the filter types, from Low-Pass to Notch to High-pass. This parameter is only available when the filter type is set to SVF for State Variable Filter. -or- Set the EQ gain. This parameter is only available when the filter type is set to Bell EQ. |
Select a filter type and slope. Read the chart below for details on every filter available. This parameter cannot be modulated. |
Page 2 DCAsis the same as page 1, but controls Filter 2. In order to unlock it, you need to have the Routing on page 3 on a setting other than Single.
Filter types reference:
| Off | SVF | K35 LP12 / HP6 | TLD LP 6/12/18/24 | TLD N 12/24 |
| The filter is bypassed | State Variable Filter model. Use Knob 3 to morph between filter types | Korg 35. Inspired by the MS-20 filter. |
Transistor Ladder Filter model. Inspired by the classic Moog filter. Low-Pass with a selection of slopes from 6dB/oct to 24/dB/oct | Transistor Ladder Filter model. Inspired by the classic Moog filter. Notch filter with 12dB/oct and 24dB/oct slopes |
| TLD BP 12/24 | DLD LP24 | COMB +/- | FORMANT | BELL EQ |
| Transistor Ladder Filter model. Inspired by the classic Moog filter. Band-pass with 12dB/oct and 24dB/oct slopes |
Diode Ladder Filter model. Inspired by the TB-303 filter. Low-pass with a steep 24dB/oct slope. | Comb filter for hollowed-out sounds and wooshes effects. With positive or negative feedback (resonance) | Formant filter for vowel sounds. Morph through A-E-I-O-U with Knob 1. | Simple 1-band equalizer to increase or decrease a selected frequency region. Knob 2 will adjust the bell width and Knob 3 will set the gain |
Page 3 allows for filter routing options:
| Routing | Balance between filter 1 and 2 | - | - |
| Select a routing configuration for the filters. Single enables only filter 1. Serial routes the output of Filter 1 to Filter 2. Para will route both filters in parallel Split will split the sound sources into the two filters, depending on the Machine select. |
Controls the volume of both filters at the output. Fully clockwise only filter 2 will be heard, and fully counter-clockwise it will be only filter 1. | - | - |