Sample Player

General information

This Machine is a basic Sample Player with loop capabilities and a couple of lo-fi effects.
The sample then goes into a Filter section, then an Amp section before going to the Mixer. Read the corresponding sections of the manual to know more about the Filter and Amp sections.

When opening the Sample Player Machine you will land on page 1 of tab 1. Use the first 2 tabs to configure the sample player. Use Tab 3 to configure the Filter section and Tab 4 to configure the Amp section.

Click the encoder to load a specific sample from the browser. While in the browser, click Button 4 to enable auto-loading of the sample for a quick preview. Once a sample is loaded, turning the encoder will scroll through other samples in the current folder. A pop-up screen will display, showing the waveform of the sample in the same way as on Tab 2.

General tab

AThis sawtab wavecontains withbasic Sync capabilities.
The oscillator tabs have 2 pages. Page 1 is the same as mentioned earlier.

Page 2:
utilities

wave is synced to a master oscillator. This adjusts

SyncFrequency	PhaseModTranspose	-	-Volume
Above 0%,Fine-tune the sawsample	Tune the frequencysample ofin thesemitone slave oscillator you're hearing. Modulate for classic sync sounds	Above 0%, the saw wave's phase is modulated by another oscillator tuned at 0.75 times the frequency of the Saw. Increasing the parameter augments the modulation depthincrements	-	-Set the amplitude at which the sample is sent into the Filter Section. 100% is unity gain, beyond that the output is amplified, useful for quiet samples or driving the Filter and Amp sections (or even overdriving the final DAC).

Sample tab

AManipulate swarmthe ofsample detunedfile sawand waves.how it's played back.
The sample tab (Tab 2) has 2 pages containing different controls.. When a Tab header displays small bar icons, click its corresponding button underneath to jump between its pages.

Page 1:

Start	Loop	Length	Playmode
-Select the point at which the sample file is launched	-Select the point from which the sample will loop, if one of the loop modes is activated	-Select the point at the the sample will stop playing	-Choose how the sample file is played. Forward, Forward Loop, Reverse, Reverse Loop. This parameter cannot be modulated.

d

Page 2:

Decimator	Sample Rate Reducer	Noise	-
-	-	-	-

d