Sample Player
General information
This Machine is a basic Sample Player with loop capabilities and a couple of lo-fi effects.
The sample then goes into a Filter section, then an Amp section before going to the Mixer. Read the corresponding sections of the manual to know more about the Filter and Amp sections.
When opening the Sample Player Machine you will land on page 1 of tab 1. Use the first 2 tabs to configure the sample player. Use Tab 3 to configure the Filter section and Tab 4 to configure the Amp section.
General tab
A saw wave with Sync capabilities.
The oscillator tabs have 2 pages. Page 1 is the same as mentioned earlier.
Page 2:
| Sync |
PhaseMod |
- |
- |
| Above 0%, the saw wave is synced to a master oscillator. This adjusts the frequency of the slave oscillator you're hearing. Modulate for classic sync sounds | Above 0%, the saw wave's phase is modulated by another oscillator tuned at 0.75 times the frequency of the Saw. Increasing the parameter augments the modulation depth |
- | - |
Sample tab
A swarm of detuned saw waves.
The sample tab (Tab 2) has 2 pages containing different controls.. When a Tab header displays small bar icons, click its corresponding button underneath to jump between its pages.
Page 1:
| Start | Loop | Length | Playmode |
| - | - | - | - |
d
Page 2:
| Decimator | Sample Rate Reducer | Noise | - |
| - | - | - | - |
d